SGT-LD-5-23 Quick Installation Guide V2.1.10 October 2010
Ground the wire The SGT-LD-5-23 is shipped with a grounding wire. The unit must be properly grounded to protect against power surges. The groundin
Warning: Make sure that the PoE is correctly connected to the RJ-45 port on the SGT-LD-5-23 labelled PoE+Data. DO NOT connect to the port labelled
Chapter 4 Configuration Connect the SGT-LD-5-23 to a Local Computer If you are configuring the SGT-LD-5-23 locally (without connecting its po
Note: Considering convenient configuration, it is recommended to configure local and remote SGT-LD-5-23 respectively on two computers. TTL time ma
How to Establish Wireless Bridge Mode The SGT-LD-5-23 supports four operating modes, which are Base Station, CPE, Peer-to-Peer (CSMA) and Peer-to-P
same network segment. e.g. local SGT-LD-5-23 as 192.168.1.1 and remote SGT-LD-5-23 as 192.168.1.2 and set the IP Subnet Mask on both as 255.255.255.
Login to the Web-based interface of the remote SGT-LD-5-23, open “About” in “System” and record its wireless MAC address. Login to the Web-base
Warning: The MAC address on the housing of SGT-LD-5-23 is the ETH MAC address; therefore it cannot be used in Peer-to-Peer links. The IP address o
Fix the local antenna and adjust the remote antenna elevation and horizontal direction. During the adjustment, observe “Current RSSI” in the local S
Chapter 5 Troubleshooting This chapter provides troubleshooting procedures for basic problems with the SGT-LD-5-23. Q 1. What if my SGT-LD-5-23 fa
Copyright Copyright © 2010 - all rights reserved. No part of this publication may be reproduced, adapted, stored in a retrieval
Chapter 1 Introduction Introduction The SGT-LD-5-23 is a high-performance outdoor-deployable radio bridge that provides radio connectivit
Chapter 2 Preparation before Installation This chapter describes safety precautions and product information that you have to know and check before
Installation Precautions To keep the SGT-LD-5-23 in good condition while you are installing it (and for subsequent high performance), please read a
Mounting Kit Wall/Pole Mounting Bracket 1. T-Form Bracket ×1 2. Articulation Pole ×1 3. Pole Mount Bar ×1 Fasteners 4. M8×80 Screw
Chapter 3 System Installation Assemble the Mounting Bracket 1 Place the main bracket into the seating and use a spanner to fasten the bracket to
Pole Mounting 1 Install the main bracket and the pole mount bar over the top of the pole by securing the drill holes of the pole mount bar to the
Connect Up Before installing the Ethernet cable with a waterproof RJ-45 connector, it is recommended that the Cat-5 RJ-45 cable be used for the bri
Commentaires sur ces manuels